Home / Patio Doors / 40 Literarywondrous Andersen 400 Series Frenchwood Hinged Patio Door Pictures Concept / Literarywondrous Andersen Series Frenchwood Hinged Patio Door Pictures Concept Plane Lands Without Nose Gear Brexit Divorce Bill Sutherland
Vallee Patio Doors November 11th, 2017 - 02:56:55
Remove the two screws holding the bottom section of the frame. There is one screw either side of the bottom section. Once these have been removed the bottom section can be prized away from the rest of the frame. Be careful not to lever against the glass or you could shatter it. When the bottom section is clear from the rest of the frame you will be able to remove the wheels. Some wheels have a screw holding them in and some are pressed into a holding bracket. If the retaining screws have rusted you can carefully drill them out, taking care not to make the hole in the bottom section any bigger. Contact your local Hardware Store, Glazing Shop or search on Google for replacement wheels.
A visible "kitemark" on the glass is the consumers assurance that the double-glazed unit has been manufactured to British standards. The BSI has numerous standards, including: U-value verification, Window Energy Rating and Window Installation. The lower the U-value, the better the thermal performance and most local authorities will require this to be 1.8 or better to meet building regulations.
The patio wheel adjusting screws are located at either end of the bottom section of the door. Some patio doors have a blanking plug covering the adjustment hole, remove the plug and use a torch to shine into the bottom section of the door to determine where the screw is located and what type of screw it is. There maybe two screws that are visible, one is an adjustment screw and the other is a fixing screw that holds the patio frame together. Use a long screwdriver to turn the adjusting screw in a clockwise direction to raise the patio. Adjust both wheels the same and check if the patio is level by almost closing the door and noting the gap between the door and the frame. Adjust the wheels until the gap is even all the way down. You may need to move the door locking keeper on the frame after adjusting the wheels. If this didnt solve the problem you may need to replace the patio wheels.
Patios are designed to be a continuation of the house into the backyard area, and with this in mind, the doors often have quite a bit of glass in them to offer you a good view. While you may enjoy this view, the thing is, there are times when youd like to have some privacy separating you from others outside and vice versa. Controlling the amount of sunlight that enters the home through the patio doors is another issue of concern. Bright light shining into a room isnt always desirable, so you need a solution that solves both problems at the same time.